Home >
COPY > [Output Setting] > [Multi Half] > [(2)2-Side Slitting]
[(2)2-Side Slitting]
Overview
Configure the setting to slit both edges of Multi Half Fold paper.
- Multi Half Fold sheets are output to the Bundle exit tray. Set the Extension tray of the bundle exit tray as preparation, and open the Stopper. Otherwise, the output paper may drop down from the Bundle exit tray. Also, the full-load detection function may not work.
- When using thin paper that curls easily for Multi Half Fold, output prints so that paper is curled toward the inside. Before outputting a booklet, print out just a few sheets to the Secondary (sub) tray, and check the direction of the curl. If the printed-out sheets are curled upward, the paper is curled inward when a booklet is created.
Setting Procedure (Setting [(2)2-Side Slitting])
Specify [Slitting] and [Offset against Cover].
1
Press [ON] in [(2)2-Side Slitting].
The setting screen is displayed.
2
Select [(1)] or [(2)] of [Slitting], and use the on-screen keypad to enter the slitting amount.
Range: 8.0 mm to 26.0 mm
Pressing [,]/[+] increases or decreases the numeric value in steps of 0.1 mm.
Use [+ / -] to set the plus or minus of the numeric value.
When the slitting amount is different between [(1)] and [(2)] by 10.0 mm or more, its value cannot be entered.
3
Select [Offset against Cover], and use the on-screen keypad to enter the slitting amount of the body for the cover.
Range: -1.0 mm to +1.0 mm
This function is available when [With Cover] is selected in [Booklet] of [Application].
Pressing [,]/[+] increases or decreases the numeric value in steps of 0.1 mm.