[Spine Corner Forming]
Overview
Form the spine corner for Fold & Staple paper.
NOTICE
- The folded and stapled sheets are output to the Bundle exit tray. Set the Extension tray of the bundle exit tray as preparation, and open the Stopper. Otherwise, the output paper may drop down from the Bundle exit tray. Also, the full-load detection function of Saddle Stitcher SD-513 may not work.
- When using thin paper that curls easily for Fold & Staple, output prints so that paper is curled toward the inside. Before outputting a booklet, print out just a few sheets to the Secondary (sub) tray, and check the direction of the curl. If the printed-out sheets are curled upward, the paper is curled inward when a booklet is created.
Tips
- When [Spine Corner Forming] is selected, [Spine Corner Forming] has priority, and [Crease] is not available.
Reference
- For details about [Crease], refer to [Crease].
Setting Procedure (Setting [Spine Corner Forming])
1
Press [ON] in [Spine Corner Forming].
The setting screen is displayed.
2
Select the strength.
First, set to [Normal]. If the result is not desirable, change the strength.
3
Press [Return].
4
Press [OK].
in the upper-right of a page, it turns into 
and is registered as a bookmark.