Program Job is a function that merges multiple copy jobs scanned in different settings, and prints them as a single job.
A paper tray can be set for each job, so it also possible to merge jobs of different paper sizes and paper types.
Note the following when setting [Program Job].
Automatically set to [Separate Scan].
For Punch, the same setting is applied to all jobs. The setting cannot be configured for each job.
To change the punch setting for each job, load the punched sheets in a paper tray, and set a paper tray for each job. Set the paper tray loaded with the punched sheets to [Pre-Punched] in [Paper Setting].
Up to 10,000 pages can be scanned.
[Program Job] cannot be registered in the Copy Mode Memory.
The following copy conditions can be set. For details, refer to [Job Ticket] - [Job Ticket Edit].
Merge multiple copy jobs, and print them as a single job.
Returns to the [COPY] screen.
The original is scanned. When scanning is completed, the [Program Job Edit] screen is displayed.
[Bunch Done]: Merges scanned jobs and applies them as a single job.
[Done&Division]: Sets Staple for each job. The jobs processed by subset stapling are merged as a single job.
[Bunch Cancel]: Cancels all the scanned jobs and returns to the [COPY] screen.
When changing copy conditions after merging all jobs, press [Complete/Edit] to display the [Program Job Edit] screen. After the change, press [Complete All].
When you pressed [Bunch Done] or [Done&Division] without pressing [Complete All], or you pressed [Bunch Done] on the [Program Job Edit] screen displayed by pressing [Complete/Edit], press Mode Check on the Control panel to return to the [Program Job Edit] screen.