RAW printing is performed via the network by directly specifying the RAW port (Port9100) of the machine as a destination printer.
To use RAW printing, follow the steps below to configure the required setting.
Configure the setting to connect to the network, for example, specifying the IP address of this machine.
For details about the setting procedure, refer to TCP/IP connection.
If necessary, change the RAW port number.
Setting using Web Connection:
Network tab - TCP/IP Setting - TCP/IP Setting - RAW Port Number.
For details, refer to [TCP/IP Setting].
Setting using the control panel:
On the control panel, press Utility/Counter - Administrator Setting - Network Setting - NIC Settings - TCP/IP Settings - RAW Port Number.
Configure settings on the computer side.