Changing the Method

The following flows are available to adjust the image quality.

  • Adjustment flow when changing the screen

  • Regular adjustment flow (Standard)

  • Regular adjustment flow (High accuracy)

In the regular adjustment flow (standard), perform color density control or standard calibration.

In the adjustment flow for changing the screen, select the desired screen, and perform gamma automatic adjustment and density balance adjustment. Then, perform color density control or standard/advanced calibration.

In the regular adjustment flow (high accuracy), perform gamma automatic adjustment and density balance adjustment, then perform color density control or standard calibration.

For details about the flow, refer to Color Management Adjustment Flow.

For details about Color Density Control, refer to Overview of Color Density Control.

You can execute calibration by using the colorimeter on Color Centro.

The accuracy of the color density control is the same as that of calibration by using the colorimeter on Color Centro.

The color density control judges the timing when the machine performs automatic adjustment. The required time period is approximately 1 min.

The calibration utilizing the colorimeter on Color Centro judges the timing when a user performs manual adjustment. The required time period is approximately 10 min.

This section describes how to calibrate by using a colorimeter on Color Centro.

If you select ON in Adjustment - Quality Adjustment - Color Density Control - Basic Setting - Use Color Density Control on the machine side, you cannot perform calibration by using a colorimeter because calibration data is automatically generated.

  1. Set Use Color Density Control of the main body to OFF.

    The colorimeter becomes available. You can also execute calibration by using the colorimeter on Color Centro.