Originals That Cannot Be Loaded on the ADF
Overview
Originals that are in any of the states detailed below cannot be loaded in the ADF. For originals for which the size does not match, or originals that cannot be loaded in the ADF due to their poor condition, load them onto the Original glass and copy them there.
Originals that are curled up, or that have wrinkles or folds
Originals that are laminated or have cut-outs
Originals that are bound like books
Originals that are not actually paper such as overhead projector transparency film, artist paper and cellophane
Originals that are folded in half, that have lots of holes, or that contain staples
Thick paper that is not particularly flexible, or thin paper such as airmail labels
Reference
- For the original sizes that can be detected using the Original glass, refer to Document Option Names and Specifications.
Display | Caution / Warning During Work |
|---|---|
 |
|
There is a risk of injury if the Original glass breaks. | |
Do not use original documents that are heavy. When using thick original documents, do not press down on them strongly. |
Warning, Risk of InjuryProcedure
1
Open the ADF.
2
Place the original so that the side that is to be copied is facing downward, and align it so that it is up against the left and far edges.
Loading the paper with the wrong orientation may cause in an undesired copy result. Take particular care regarding this when configuring the various functions for performing 2-sided copying, stapling, fold & stapling, multi half folds, and booklet finishing.
If you have selected [NoImageAreaErase], scan the original without closing the ADF.
3
Slowly close the ADF so as not to move the original document.
4
Set copy conditions and make copies.
in the upper-right of a page, it turns into 
and is registered as a bookmark.