Originals With Mixes of Different Size Dimensions
Overview
Load originals with mixes of different size dimensions into the ADF and copy them.
Configure the following functions when copying originals which have a mix of different size dimensions.
[Special]: Set whether or not the widths of the originals are all the same.
[Auto Paper] or [Auto Zoom]: Set whether to make copies onto paper that is the same size as the original, or to automatically change the zoom ratio.
[Special] options | Description |
|---|---|
[Same Width] | Select this item for the original of the same width and different sizes. |
[Different Width] | Select this item for an original of different widths and different sizes. |
Selectable Items for [Auto Paper] or [Auto Zoom] | Description |
|---|---|
[Auto Paper] | Makes copies of the same size as the originals.  |
[Auto Zoom] | Automatically sets the appropriate zoom ratio for each original, and then make copies that are all the same size as the original.  |
For originals with mixed size dimensions, load the paper in the ADF so that it is aligned along the left and far edges as shown in the figure below.
Detectable original sizes: The types of original sizes that can be detected when the sizes are mixed vary depending on the opening width of the Original guides, as shown below.
For A3 w, A4 v opening widths: A3 w, B4 w, A4 w / v, B5 v
For B4 w, B5 v opening widths: B4 w, A4 w, B5 w / v, A5 v
For A4 w, A5 v opening widths: A4 w, B5 w, A5 v
For B5 w opening widths: B5 w, A5 w
For A5 w opening widths: A5 w, B6 w
For B6 w opening widths: B6 w
Reference
- For details about [Special], refer to [Special].
Procedure
1
Place the originals in order starting from page 1.
For originals with mixed size dimensions, load them in the ADF so that they are aligned along the left and far edges.
NOTICE
- Loading so many originals that they exceed the original loading capacity or the maximum stack height line displayed on the Original guides may cause paper jams, damage the document, or cause a machine malfunction.
- Never load originals that have been stapled or fastened with paper clips. Doing so may damage the original.
2
Place the Original guides flush against the original.
Do not open and close the ADF once closed for operation as doing so may cause the pre-configured copy conditions to change.
3
Set the copy conditions.
Set [Special] of [Original Setting] according to the original document.
Set to [Auto Paper] or [Auto Zoom] on the [COPY] screen.
4
Specify other copy conditions and perform copying.
in the upper-right of a page, it turns into 
and is registered as a bookmark.