When Printing Multiple Jobs Together, No Partition Papers Are Added to Separate the Jobs.
Cause
Target option: Fiery color server
The Job Batch function*1 and Partition Paper function*2 cannot be used together.
When the job batch feature is applied, multiple jobs are combined into a single job, so no partition paper is included.
*1: When print instructions are applied to multiple small jobs at once, the controller automatically combines a group of small jobs into a single job to improve printing efficiency.
*2: A function that places sheets of partition paper between jobs.
Setting Procedure
Work Time: 5 mins or less
This section describes the procedure for turning off the Job Batch function and using the Partition Paper function.
If there is already RIP-processed data, a re-RIP is required.
The following procedure shows an example for the Fiery color server.
1
Turns off the Job Batch function. Launch [Configure] in Command WorkStation or Fiery WebTools.
2
In [Job Management], set the [Job Patch] check box to OFF.
3
Revert RIP-processed data back to pre-RIP data. Right-click the job in Command WorkStation and select [Remove Raster Data].
4
Select the job, right-click, and then open [Properties].
5
Select [Offset Sort] for [Sort/Group] under [Finish], and then select [Print].
Re-applying RIP processing enables the job ticket that specified the partitioning function, thereby preventing this issue.
in the upper-right of a page, it turns into 
and is registered as a bookmark.