[IPv4 Settings]

Configure settings for using the system while connected in a TCP / IP environment.

In particular, you can check and configure IP addresses, set up DNS servers, and configure IPSec if necessary.

Use IPv4 when you want to set an IP address "xxx.xxx.xxx.xxx" on the system.

NOTICE

• Do not set the following combination for IPv4.
  IP address: 203.0.113.1

1

Press Utility/Counter, and then press in order of [Administrator Setting] - [Network Setting] - [NIC Settings].

2

Press [TCP/IP Settings].

3

Press [ON].

4

Press [IPv4 Settings] and then select [Manual Input] or [Auto Input].

• [Manual Input]: Manually configure the IP address (if required, you can also configure the subnet mask and default gateway).

• [Auto Input]: The IP address is assigned automatically. As such, you do not need to manually set the IP address.

5

Press [OK].

1

Press Utility/Counter, and then press in order of [Administrator Setting] - [Controller] - [TCP/IP Setting].

2

Press [Enable] on the [TCP/IP Setting].

3

Press [Direct Setting] or [Auto Setting] on the [IP Address Set Method].

• [Direct Setting]: Manually configure the IP address (if required, you can also configure the subnet mask and default gateway).

• [Auto Setting]: The IP address is assigned automatically. As such, you do not need to manually set the IP address.

4

Press [OK].