From among the methods for restricting access to the machine and Image Controller, there are methods for allowing only devices which are within the range set for the machine and Image Controller.
Set the range of allowed IP addresses so that any devices which are not in range are denied access. The range of allowed IP addresses can be quickly and easily checked, making it an extremely useful function.
Configure the settings as detailed below to restrict the range of IP addresses that can communicate with the machine.
The figure below is an example of simple IP filtering.
A: "Outside" of the allowed IP address range
B: "Within" the allowed IP address range
If using IPv4, only addresses which are within the permitted range of IP addresses are allowed. The subnet mask is fixed at 255.255.255.0.
If using IPv6, only IP addresses configured to the machine or Image Controller, and IP addresses with the same high-order 64 bits are allowed access.
<Example>
With Machine or Image Controller IP Address: 10.11.32.2
Range of IP Addresses with Access to System: 10.11.32.0 to 10.11.32.255
*: The subnet mask is fixed to 255.255.255.0
Use the subnet mask and IP address configured to the machine or Image Controller to allow access only to those within the range of IP address belonging to the same sub network.
<Example>
With Machine or Image Controller IP Address: 10.11.32.2, and Machine or Image Controller Subnet Mask: 255.255.248.0
Range of IP Addresses with Access to System: 10.11.32.0 to 10.11.39.255
Allow connections from all IP addresses without using the filtering function.
You can check which range is enabled.
You can check which range is enabled.