Lead Edge Erase Adjustment

Adjust the amount of image to be erased from the edge of the sheet.

Adjustment Range: -20 to +40 (1 step = 0.1 mm)

  1. Follow the procedure on Displaying the [Administrator Setting Menu] Screen to display the Administrator Setting Menu screen.

  2. Press System Setting on the Administrator Setting Menu screen, and then press Expert Adjustment, Printer Adjustment, and Lead Edge Erase Adjustment in sequence.

    The Lead Edge Erase Adjustment screen is displayed.

  3. Press Print Mode.

    The PRINT MODE screen is displayed.

  4. Select A3 short edge feed paper, then press Start on the control panel.

    A sample pattern will be output.

  5. Press Exit PrintMode to return to the Lead Edge Erase Adjustment screen.

  6. Measure the resultant restart timing.

  7. If any adjustment is required, enter the desired adjustment value using the touch panel keypad.

    • supplementary explanationUse +/- to specify the value to be positive or negative.

    • supplementary explanationPress Set to change the current value.

  8. Repeat steps 3 to 7 until the desired result is obtained.

  9. Press Return to return to the Printer Adjustment Menu screen.