Staple Paper Width Adj.
Adjust the width of the exit guides of Saddle Stitcher SD-513 to be used in Staple mode to reduce misalignment and skew in paper.
Objects of Adjustment: Offset for All Size, SRA3 short edge feed, A3 short edge feed, B4 short edge feed, SRA4 short edge feed, A4 short edge feed, B5 short edge feed, 12 18 short edge feed, 11 17 short edge feed, 8.5 14 short edge feed, 8.5 11 short edge feed, 8 13 short edge feed, 8K short edge feed, 16K short edge feed, Custom (380 to 488 mm), Custom (257 to 379 mm), 13 19 short edge feed
NOTICE
If a numeric value is specified for Offset for All Size, it is applied to all paper sizes. With a specific paper size selected,the set value becomes the sum of the entered value and the value previously specified for Offset for All Size.
Press Adjustment on the MACHINE screen to display the Adjustment Menu screen.
Press Finisher Adjustment, Saddle Stitcher Adjustment, and Staple Paper Width Adj. in sequence.
Select the size to be adjusted using down or up.
Press Print Mode.
Load the paper with the size to be adjusted, then select that tray.
Press Start on the control panel.
A sample pattern will be output.
Check if the stapled set shows misalignment (a), (Caused if specified paper width is larger than the actual width.) or is curved (b). (Caused if specified paper width is smaller than the actual width.)
Allowance: a = 1 mm or less
If any adjustment is required, press Exit PrintMode to return to the Staple Paper Width Adjustment screen.
Use the touch panel keypad to enter the set value.
supplementary explanationUse +/- to specify the value to be positive or negative.
supplementary explanationPress Set to change the Current Value.
supplementary explanationAdjustment Range: -20 (To reduce the dispersion) to +20 (To reduce the distortion) (1 step = 0.1 mm)
Repeat steps 4 to 9 until the desired result is obtained.
Press Return.
The screen returns to the Saddle Stitcher Adjustment Menu screen.