Registration Adjustment

If the punch position is not parallel to the paper edge for output, control paper curling and wrinkling by adjusting the paper loop of the registration roller in Punch Kit PK-522 mounted on Finisher FS-532.

1. Press Adjustment on the MACHINE screen to display the Adjustment Menu screen.

2. Press Finisher Adjustment, Staple Finisher Adjustment, Staple Finisher(Punch) Adj., and Registration Adjustment in sequence.

3. Press Print Mode.

4. Load the desired paper into a tray, then select that tray.

   • supplementary explanationFor Output Setting, Punch is automatically selected.

5. Press Start on the control panel.

   A sample pattern will be output.

6. Check if the punch holes are skew on the printed paper.

7. Press Exit PrintMode to return to the Registration Adjustment screen.

8. If any adjustment is required, use the touch panel keypad to enter the set value.

   • supplementary explanationAdjustment Range: -50 (Short) to +50 (Long) (1 step = 0.1 mm)

   • supplementary explanationPress +/- to specify the value to be positive or negative.

9. Press Set to change the setting with the Current Data.

10. Repeat steps 4 to 10 until the desired result is obtained.

11. Press Return.

    The screen returns to the Staple Finisher(Punch) Adjustment Menu screen.