Staple Position Adjustment

Adjust 2 position staple pitch and corner staple positions in the staple finisher.

Objects of adjustment: 2 Position Pitch (120 mm), 2 Position Pitch (140 mm), 2 Position Pitch (165 mm), Rear Diagonal, Rear Parallel, Front Parallel

1. Press Adjustment on the MACHINE screen to display the Adjustment Menu screen.

2. Press Finisher Adjustment, Staple Finisher Adjustment, Staple Finisher(Main) Adj., and Staple Position Adjustment in sequence.

3. Select 2 Position Pitch(120mm), 2 Position Pitch(140mm), 2 Position Pitch(165mm), Rear Diagonal, Rear Parallel, or Front Parallel to adjust the staple position.

4. Press Print Mode.

5. Load the desired paper into a tray, then select that tray.

   • supplementary explanationFor Output Setting, Staple is automatically selected, and the staple position selected in step 3 is selected.

6. Press Start on the control panel.

   A sample pattern will be output.

7. Check the staple positions (a) of the printed paper.

   • supplementary explanationWhen 2 Position Pitch(120mm), 2 Position Pitch(140mm), or 2 Position Pitch(165mm) is selected:
     Allowance for 2 Position Pitch(120mm): a = 120 mm ± 3 mm
     Allowance for 2 Position Pitch(140mm): a = 140 mm ± 3 mm
     Allowance for 2 Position Pitch(165mm): a = 165 mm ± 3 mm

   

   • supplementary explanationWhen Rear Diagonal is selected:
     Allowance : a = 15.2 mm ± 3 mm

   

   • supplementary explanationWhen Rear Parallel is selected:
     Allowance: a = 19.6 mm  ± 2 mm

   

   • supplementary explanationWhen Front Parallel is selected:
     Allowance: a = 6.4 mm ± 3 mm

   

8. Press Exit PrintMode to return to the Staple Position Adjustment screen.

9. If any adjustment is required, use the touch panel keypad to enter the set value.

   • supplementary explanationAdjustment range for 2 Position Pitch(120 mm), 2 Position Pitch(140 mm), and 2 Position Pitch(165 mm):
     -5 (Narrow) to +5 (Wide) (1 step = 1.0 mm)

   • supplementary explanationAdjustment range for Rear Diagonal:
     -5 (Narrow) to +5 (Wide) (1 step = 1.0 mm)

   • supplementary explanationAdjustment range for Rear Parallel and Front Parallel:
     -3 (Narrow) to +3 (Wide) (1 step = 1.0 mm)

   • supplementary explanationUse +/- to specify the value to be positive or negative.

10. Press Set to change the setting with the Current Data.

11. Repeat steps 4 to 10 until the desired result is obtained.

12. Press Return.

    The screen returns to the Staple Finisher(Main) Adjustment Menu screen.