A. Various types of paper can be used on this system. The paper that can be used depends on the options mounted in the system.
For details, refer to Name and Specifications of Each Component in the Machine and Optional Part Names and Specifications for Paper Feed.
However, some paper types are not suitable for printing on this system. For details about the paper types available on this system, contact your service representative.
Using the following paper may cause a failure because the adhesive surface may adhere to various parts inside the system during paper feeding. When using this function, be sure to contact your service representative in advance.
A. The maximum number of loadable sheets varies depending on the target paper tray or paper type.
For details, refer to Name and Specifications of Each Component in the Machine or Optional Part Names and Specifications for Paper Feed.
A. Yes, there is.
[Secure Print] is useful to print job a highly confidential job. For details, refer to [Workflow].
A. Yes, you can.
In the [JOB LIST], use [Overlay] in [Job Ticket Edit].
For details, refer to [Overlay].
In the PS Plug-in Driver, use [Form].
For details, refer to [Forms].
In the PPD Driver, use [Copy Protect].
For details, refer to [Advanced Document Settings].
In the PCL Driver, use [Overlay] in [Stamp/Composition].
For details, refer to PCL Driver and PCL Driver of [Help].
A. You can store the copied or scanned data. Only the jobs scanned on this system can be stored on the HDD of the machine.
A job printed from a printer driver, etc. can be stored on the HDD of Image Controller.
A. Yes, you can.
To confirm the installed fonts, print the font list.
For details, refer to [Report Type].
A. Yes, you can.
You can create and combine any subfolder directly under [pdfvt] of the SMB shared folder.
For details about combining, refer to PDF/VT-2 Variable Printing of Print Manager or [Workflow] of PS Plug-in Driver.
A. Yes, you can.
To use PS Plug-in Driver for printing:
- Configure the setting on the [Layout] screen. For details, refer to [Layout].
To use PPD Driver for printing:
- Configure the setting in [180°Rotate]. For details, refer to [Advanced Document Settings].
A. Yes, you can.
You can perform cutting for finishing. For details, refer to Before Card Cutting or "Trim Printing" in [Print Workflow].
A. If the trimmed part is misaligned, there are two possible causes.
Cause
(1) A print (image position) on paper is misaligned.
(2) The position of the paper cutting blade (trim position) is misaligned.
* When the image position of (1) is misaligned, the trimmed part is misaligned even if the trim position of (2) is correct.
Therefore, carry out the following check and adjustment.
Countermeasures
(1) Adjust the image position on a daily basis so that the image position is not misaligned.
(2) Be sure to check that the image position is not misaligned first before adjusting the trim position.
A. Yes, you can.
You can combine hold jobs and print them as a single job. For details, refer to [Combine].
A. The setting is not applied to the combined job.
The combined jobs are stored as a new hold job.
A. When the number of hold jobs reaches the maximum, the next hold job is not received. Delete unnecessary hold jobs, and then store a job again.
For information about the upper limit of hold jobs, refer to [Hold Job].