Home >
Advanced Function > Configuring the Serverless Pull Printing Environment > Using LK-114_SetupTool (for the administrator) > About LK-114_SetupTool
About LK-114_SetupTool
About LK-114_SetupTool
LK-114_SetupTool is an application for building a serverless pull printing environment.
You can also create a configuration file to load into LK-114_ManagerPort from the configuration information of the serverless pull printing group managed by LK-114_SetupTool.
- LK-114_SetupTool is not available in the IPv6 environment. To use the serverless pull printing function in the IPv6 environment, configure settings on the MFP.
System environment requirements
For details on the system requirements, refer to LK-114_SetupTool (for the administrator).
Preparation required to use this function
To use LK-114_SetupTool, configure NetBIOS settings on the computer.
1
In Windows, open the Start menu, and click [Settings].
2
Click [Network and Internet].
3
Click [Advanced network settings] - [More network adapter options].
4
Right-click the network connected to this machine, then click [Properties].
5
From the connection item list, select [Internet Protocol Version 4 (TCP/IPv4)], then click [Properties].
7
On the [WINS] tab of the [Advanced TCP/IP Settings] page, configure NetBIOS settings, then click [OK].
Clear the [Enable LMHOSTS lookup] check box.
In [NetBIOS setting], select [Disable NetBIOS over TCP/IP].
8
From the Start menu, click [All apps] - [Windows Tools] - [Command Prompt].
9
Execute the "ipconfig /flushdns" command.
Insert a space between "ipconfig" and "/flushdns".
When the processing is completed normally, a message is displayed as shown in the figure.
10
Close [Command Prompt].
NetBIOS settings are then completed.