[TCP/IP Setting]

Configure the IP address and network settings of this system.

[E-mail Setting]

Set the server that communicates with this system when sending/receiving emails on this system.

[LDAP Setting]

Configure the settings to allow LDAP server registration and destination searches from Active Directory.

[FTP Setting]

Set the proxy server that communicates with this system for FTP transmission, or configure the setting required to use this system as an FTP server.

[SNMP Setting]

Configure the setting to acquire or monitor information of this system using SNMP (Simple Network Management Protocol).

[SMB Setting]

Configure the client settings for SMB (Server Message Block) transmission and the settings required when using this system as an SMB server.

[DPWS Settings]

Configure various settings for the Web service function (DPWS: Devices Profile for Web Services).

[WebDAV Settings]

Set the proxy server that communicates with this system for WebDAV transmission, or configure various settings required to use this system as a WebDAV server.

[OpenAPI Setting]

Configure settings for using the application that communicates with the system through OpenAPI.

[TCP Socket Setting]

Configure the setting to communicate with this system using TCP Socket.

[IEEE802.1X Authentication Setting]

Configure the environment to use the IEEE802.1X authentication, or perform the configured authentication trial.

[LLTD Setting]

Configure the setting to use LLTD (Link Layer Topology Discovery).

[SSDP Settings]

Configure the setting to use SSDP (Simple Service Discovery Protocol).

[IWS Settings]

Configure the setting to use the IWS (Internal Web Server) function.

[Remote Panel Settings]

Use the remote diagnostic system to set whether the administrator allows the customer engineer to operate the remote panel.