Enter the destination.
Manually enter a destination. When sending a job to an unregistered destination, set this item.
The registered name is displayed on the destination key.
Up to 24 single-byte characters (12 double-byte characters) can be entered.
Up to 24 single-byte characters (12 double-byte characters) can be entered.
When [Reference Name] is registered, the 1st character will be the search target.
When [Register Name] is entered, the same text as [Register Name] is registered automatically. Change the name as necessary.
Up to 253 single-byte characters can be entered.
Up to 255 single-byte characters (127 double-byte characters) can be entered.
Enter a "shared folder name" or a "shared folder name\sub folder name" (use "\" as a separator).
SMB can be entered using up to 32 single-byte characters (16 double-byte characters).
Up to 32 single-byte characters can be entered.
The entered password is shown by "1".
Searches for a destination in the browser list on the network.
The path of the selected destination is displayed in [Destination].
If the path display is long, you can press [<]/[>] to move the display left or right and see the entire display.
When the list consists of more than one page, press [Previous] or [Next] to move to the target page.
Up to 512 workgroups can be displayed.
When the list consists of more than one page, press [Previous] or [Next] to move to the target page.
To move to the higher-level layer, press [Up].
Up to 512 computer names can be displayed.
To open the entry screen, press [Change] for each item.
To move to the higher-level layer, press [Up].
Up to 256 folders are displayed.
If the file path length exceeds the maximum (255 single-byte characters or 127 double-byte characters), it can be adjusted so that the file path is included within the maximum.