Message | Cause | Remedy |
---|---|---|
[Job was not sucessfully executed. An Error occurred while dialing. Please check Job History.] | Redial was attempted the number of times specified, however, transmission failed because the recipient was busy or due to other reasons. | Check the recipient's state and then resend the fax. Using the Off-Hook key, you can check the sender status before sending. For details, refer to Sending after Checking the State on the Recipient Side (Manual Transmission). |
[Unable to check sender.] | The machine failed to verify the recipient with Check Dest. & Send set to ON. | Check whether the fax number of the originating machine is registered in the destination machine. |
[Not enough memory to continue scanning. Touch [Send] to transmit only the scanned portion of the document or [Delete] to cancel it.] | All the available space in the memory has been used up by document scanning. | To send the scanned document, use the Start key to start sending. To stop sending, use the Stop key. |
[Transmission failed. Please check line connection.] | The modular cable may be disconnected. | Check the modular cable connection and, if unplugged, plug it in securely. |
[Failed to connect to server.] | The network cable is not connected correctly. | Make sure that the network cable is correctly connected. |
Under Administrator Settings, [Network] is not set correctly. | Under Administrator Settings, check that [Network] is set correctly. | |
[Cannot select address for TX. Exceeded the maximum number of addresses allowed for broadcasting] | The number of destinations specified exceeds the number possible for a broadcast transmission. | Reduce the number of broadcast destinations, or send the transmission in multiple batches. |
[Document could not be saved in User Box. Insufficient Storage memory. Please check Job History.] | The storage is full. | Delete unnecessary data, then try saving the data again. |
[No. of User Boxes has reached the maximum.] | The number of User Box that can be registered has reached the maximum number possible. | Delete unnecessary User Boxes then retry registration. You can select [Utility] - [Administrator] - [System Settings] - [User Box Setting] - [Delete Unused User Box] to delete a User Box that contains no files. |
[The number of documents in the box has reached the maximum limit. No additional documents can be stored.] | The number of documents that can be saved in a User Box has reached the maximum number possible. | Delete unnecessary documents then retry registration. |
[The number of programmed jobs has reachedthe maximum allowance. Please wait untila programmed job has been completed.] | The number of jobs that can be programmed has reached the maximum number possible. | Wait until a job has been completed, or delete a current job. |