Adjusting the Punch Finishing
Overview
Configure the finish by adjusting the position of punch holes.
Adjusting Punch Hole Vertical Position (Cross Direction)
Adjust the vertical position (cross direction) of punch holes and resolve any misalignment between the center of the punch hole and the center of the output paper.
Using [Stapler]
Using [Multi Folder]
Adjusting Punch Hole Horizontal Position (Feed Direction)
Adjust the horizontal position of punch holes and resolve any misalignment between the center of the punch hole and the edge of the output paper.
Using [Stapler]
Adjusting Punch Position Tilting
If [Stapler] is used, you can correct any tilt in the punch positions by increasing or decreasing the deflection (amount of loop) of the paper in the Registration roller.
Using [Stapler]
in the upper-right of a page, it turns into 
and is registered as a bookmark.