Clean the Inline Scanner of Intelligent Quality Care Unit IQ-501 if any dirt is detected, use the procedure detailed below.
Open the Intelligent Quality Care Unit front door.
Pull out the Cleaning bar from the back side of the Intelligent Quality Care Unit front door.
Insert the Cleaning bar into the Cleaning inlet of the Inline Scanner in the correct direction if any dirt that requires cleaning (paper dust, etc.) is detected. Pull out the Cleaning bar after inserting it all the way to the far end.
Return the Cleaning bar to its original location.
When returning the Cleaning bar to its home position, store it so that the Pad at the tip of the Cleaning bar faces out toward you. If the Pad is inserted facing toward the door, the pad part may become dirty or damaged.
Make sure that the tip of the Cleaning bar does not become stuck on the stopper. If you do not place it properly, the tip of the Cleaning bar may become damaged.
Close the Intelligent Quality Care Unit front door.
When the dirt has been removed by cleaning, the message disappears and the machine is ready for use.
If the message does not disappear after closing the Intelligent Quality Care Unit front door, clean the Inline Scanner indicated on the display again (1 round trip).
If the message does not disappear after re-cleaning, contact your service representative.