[Speed Adjustment]
Overview
Adjusts the speed of each roller.
Adjusts if there is a paper jam or if the paper has creased or folded.
Tips
- The available items vary depending on the optional devices mounted on this system.
Setting Items
Setting item | Description |
|---|---|
[Registration Speed] | Adjusts the Registration Roller Speed. Use this when a line appears in the main scanning direction on the image. |
[Fusing Speed(FrontSide)] | Adjusts the Fusing Roller Speed(Front Side). Use this when a line appears in the main scanning direction on the image. |
[FusingSpeed(BackOffset)] | Adjusts the Fusing Roller Speed(Back Side). Use this when a line appears in the main scanning direction on the image. |
[Reverse De-Curler Speed] | Adjusts the Reverse De-curler Roller Speed. Use this when it generates wrinkles on paper. |
[Reverse Speed(RevExit)] | Adjusts the Reversal Output Roller Speed. Use this when paper jam occurs. |
[Reverse Speed(ADU)] | Adjusts the ADU Reverse Roller Speed. Use this when paper jam occurs. |
[Banner Reverse Speed1] | Adjusts the Banner Reverse Roller Speed. Use this when paper jam occurs. |
[Output De-Curler Speed] | Adjusts the Paper Exit De-Curler Roller Speed. Use this when it generates wrinkles on paper. |
[LCT BannerRegist.Speed] | Adjusts the LCT Pre-Registration Roller Speed for the banner paper printing. Use this when a line appears in the main scanning direction on the image. |
[Regist. Speed(Banner)] | Adjusts the Registration Roller Speed when reversing banner paper. Use this when a line appears in the main scanning direction on the image. |
[Banner Reverse Speed2] | Adjusts the Loop Roller Speed when reversing banner paper. Use this when paper jam occurs. |
Setting Procedure
1
Press the key for the item to be adjusted.
Press [+]/[,] to switch the key.
2
Press [Print Mode].
3
Set paper to the paper feed tray you want to adjust and then select that respective paper feed tray.
4
Press Start on the Control panel to output a chart.
For details about the "
" mark that is printed on the front side of the chart, refer to About Charts.
5
Check to see that the paper jam has been removed and that there are no creases or folds.
6
If any adjustments are required, press [Exit PrintMode] to return to the setting screen.
7
Use the on-screen keypad or the Keypad of the Control panel to enter the numeric value.
Use [+ / -] to select the plus or minus of the numeric value. To change [Current Data], press [Set].
8
Repeat steps 1 to 7 until the desired result is obtained.
in the upper-right of a page, it turns into 
and is registered as a bookmark.