Home >
Startup Guide > Paper Loading and Settings > Loading Envelope > Loading Envelopes Into the Paper Feeder Unit PF-812
Loading Envelopes Into the Paper Feeder Unit PF-812
Overview
Load envelopes into Paper Feeder Unit PF-812.
- A: Vertical B: Horizontal
- Available size
Widthwise 210 mm to 245 mm, lengthwise 210 mm to 375 mm / Widthwise 8.27" to 9.65", lengthwise 8.27" to 14.76"
- Recommended sizes (not including flaps)
- Load capacity
100 sheets (50 sheets for K0 and K1 envelopes)
The height difference on the top of the envelope must be 10 mm / 0.39" or less.
- Unavailable envelopes
- It is recommended that you use one side seam (A) or double side seam (B) envelopes. If the sticking tab overlaps the print side, print output may be faded.
- If the machine is not powered on, the tray cannot be pulled out. Turn the Sub power switch on. For details, refer to Turning This System On.
- Do not pull out multiple trays at once. Doing so may cause the machine to topple over.
- Envelopes can only be loaded into the Lower tray (Tray 3) of the 1st paper feeder unit.
Procedure
1
Pull out the tray to load envelopes into.
2
Load envelopes into the tray with the print side facing up.
Load the envelopes against the top of the tray so that the open flaps are on the right side.
If the Side auxiliary guides is mounted, remove it. You do not need to remove the positioning screws.
3
Align the Side guides (left) of the tray with the envelopes, turn the Side guide lock knobs, and fix it.
4
Align the Rear guide plate of the tray with the envelopes.
5
Firmly push the tray all the way in.