Loading Perfect Binding Covers
Overview
Load covers used for perfect binding to the following trays.
Cover tray of Perfect Binder PB-503
Paper Feeder Unit PF-712
Paper Feeder Unit PF-713
Paper Feeder Unit PF-812
Post inserter of FoldingUnit FD-503
This section describes how to load the covers to the Perfect Binder PB-503 - Cover tray.
Tips
- Use [Paper Setting] to configure the perfect binding cover paper settings of Cover tray. For details, refer to [Paper Setting].
Procedure
1
Pull out the Cover tray.
2
Open the Feed roller.
3
Load the covers with the front side facing up.
Load the covers so that it is aligned with the Feed roller side of the tray.
When the perfect binding is set to Left Bind, set the front side of the cover up and the top of the cover on the back side of the tray. The cut part is on the left side of the loaded covers.
When the perfect binding is set to Right Bind set the front side of the cover facing up and the top of the cover facing the front of the tray. The cut part is on the left side of the loaded covers.
NOTICE
- Load the covers so that it does not exceed the line of the paper upper limit label on Side guides of the tray. Also, load the covers under Paper holding plate fixing lever in Air nozzle.
4
Align Side guides and Rear stopper with the covers.
While pressing Side guide lock release lever of Side guides on the front side, hit Side guides against the covers.
Next, hit Rear stopper against the covers.
NOTICE
- Make sure that Side guides and Rear stopper hit the covers. If there is a gap between the guide plate and the covers, it may cause a paper jam.
5
Close the Feed roller.
6
Firmly push the Cover tray all the way in.
NOTICE
- Return the tray quietly. There may be an unexpected impact on the machine because of the weight of the tray or paper causing the malfunction.
in the upper-right of a page, it turns into 
and is registered as a bookmark.