Home ScanStoring Scan Conditions

Storing Scan Conditions

Follow the procedure below to register the scan job setting.

  • Available settings: Print Side, Quality Adjustment, Scan Size, Color/Resolution, Zoom Setting, Application

  • Stored job is given a job number (from 01 to 30) and alphabetical name (dispensable).

  • A maximum of 30 scan programs can be registered.

  1. Press [SCAN] tab to display the [SCAN] screen.

  2. Select an address and press [Scan Settings].

    • Settings of Mode Memory does not include a destination that you select here.
      Select a destination only for displaying the Scan Settings screen.

  3. Set the scan conditions.

  4. Press Mode Memory on the control panel.

    The [Mode Memory Mode] screen is displayed.

  5. Press [Store].

    The screen that shows the settings is displayed.

  6. Review the settings to be stored.

    • To change the settings to register, press [Cancel] on the screen that shows the settings, and then press [Cancel] on the [Mode Memory Mode] screen. The screen returns to the screen that shows the scan settings. On the screen, change scan conditions.

  7. Press [OK].

    The Job store mode screen is displayed.

  8. Press the desired job key, then press [OK].

    The [Job Name Setting] screen is displayed.

    • If a button name is
      Not displayed: No scan conditions are registered.
      Displayed: Scan conditions are registered.

    • If a lock icon () is
      Not displayed: Scan conditions can be registered by overwriting.
      Displayed: Scan conditions cannot be registered.

  9. Enter a job name, then press [OK].

    • Enter a job name within 16 one-byte characters (8 two-byte characters).

    • Press [OK] to return to the [Mode Memory Mode] screen. The job button displays the entered job name.

    • Be sure to input a job name. The job name must be inputted to return to the [Mode Memory Mode] screen by pressing [OK].

  10. Press [OK] on the [Mode Memory Mode] screen.

    This returns to the [SCAN] screen.