Configuring Enlarge Display Operations

Change the default settings (when the power is turned on, or the Reset key is operated) in Enlarge Display mode. You can change the default setting by selecting [Current Setting] after the setting of each function is changed (default: [Factory Default]).

1

In Enlarge Display, change the setting of the function mode for which you want to change the default value.

• The default values in multiple modes cannot be changed by one operation.

2

Tap [Accessibility] - [Default Enlarge Display Settings].

3

Select a mode to change settings.

• Select the mode that was displayed before tapping [Accessibility].

4

Select [Current Setting].

• To return to the factory default settings, select [Factory Default].

5

Tap [OK].

Tips

• The default setting in the fax mode remains unchanged even if the default settings in the scan/fax mode are modified.

Changing to Enlarge Display cancels the settings configured on the normal screen. When necessary, you can display the screen to check whether to cancel the settings configured on the normal screen and change to the Enlarge Display mode.

Select [Accessibility] - [Enlarge Display Mode Confirmation], and select whether to check a change to the Enlarge Display mode by displaying the screen (default: [OFF]).

Tips

• The confirmation screen is not displayed when the display is changed to the normal screen.

If this machine is not operated in the Enlarge Display mode for a while, the Enlarge Display mode is canceled automatically. When necessary, you can display the screen to check whether to cancel the Enlarge Display mode.

Select [Accessibility] - [System Auto Reset Confirmation], and select whether to check a cancellation of the Enlarge Display mode by displaying the screen (default: [No]). When displaying the screen, select the length of time to display the screen.

If this machine is not operated for a while, settings are reset automatically. When necessary, you can display the screen to check whether to reset settings.

Select [Accessibility] - [Auto Reset Confirmation], and select whether to display the confirmation screen that enables or disables resetting of the settings. (default: [No]). When displaying the screen, select the length of time to display the screen.

In the Enlarge Display mode, pressing a key enters one character, and holding down a key starts entering successive characters. This is referred to as a key repeat.

When necessary, change the time from pressing a key to starting a key repeat, and the interval to enter successive characters.

Select [Accessibility] - [Key Repeat Start/Interval Time] to configure settings.