Making a Copy
Copying (basic operation flow)
This section describes the basic procedure to make a copy in Enlarge Display mode.
1
Load the original.
2
Tap [Copy] on the main menu of classic style.
3
Tap [Enlarge Display] in the side menu.
4
If necessary, configure copy settings.
5
If necessary, specify the number of copies using the keypad.
Tapping [Number of Sets] displays the keypad.
To change the number of copies, tap [C] (Clear).
6
Use the Start key to start copying.
To cancel copy, use the Stop key to stop copying. A list of the currently stopped jobs is displayed. Select the target job from the list, and delete it.
If [Ready to accept another job.] is displayed during printing, you can scan the next original.
Making a trial printing (proof copy)
Before beginning actual copying, do a single test copy and check it is acceptable.
When making a large number of copies, use the proof copy function to prevent a large number of miscopies from occurring.
1
Load the original.
2
Tap [Copy] on the main menu of classic style.
3
Tap [Enlarge Display] in the side menu.
4
If necessary, configure copy settings.
5
Enter the number of copies using the keypad.
Tapping [Number of Sets] displays the keypad.
To change the number of copies, tap [C] (Clear).
6
Tap [Print].
If the original is loaded into the ADF, one copy is made. Proceed to step 10.
If the original is loaded on the Original Glass, proceed to step 7.
7
Load the next original, and use the Start key to start scanning.
8
After all originals have been scanned, tap [Finish].
9
Use the Start key to start copying.
Copying begins for only one copy.
10
Check the proof copy.
11
When making the remaining copies, tap [Print].
12
Check that the remaining number of copies has been copied.
in the upper-right of a page, it turns into 
and is registered as a bookmark.