[Image Jitter(Lead/Rear Edge)]
Overview
Configure the setting to reduce occurrences of thin line and character jitter when printing.
This function is effective for thin line and character jitter that occur at the lead or rear edge of paper.
If image jitter occurs in the range of 10 mm / 0.39" from the lead or rear edge of paper even after [Image Jitter] was performed, use [Image Jitter(Lead/Rear Edge)] to make adjustments.
Tips
- Make adjustments in order from [Improvement+1].
- The higher the "+" value in the setting item is, the fewer times thin line and character jitter at the lead or rear edge will occur. However, image jitter may occur at a position other than the lead or rear edge of paper depending on the paper type.
Setting Items
Setting item | Description |
|---|---|
[Reset] | Resets the settings. |
[Improvement+1] | Reduces occurrences of thin line and character jitter. |
[Improvement+2] | Reduces occurrences of thin line and character jitter compared to [Improvement+1]. |
in the upper-right of a page, it turns into 
and is registered as a bookmark.