This section describes how to return the Color Default Settings of the image controller to the factory default.
The factory default settings are as follows;
RGB Tab | Setting |
---|---|
Off | OFF |
RGB-CMYK Device Link Profile | OFF |
RGB Source Profile | ON |
Rendering | Saturation This setting may vary depending on models. |
CMYK Tab | Setting |
---|---|
Off | OFF |
CMYK-CMYK Device Link Profile | OFF |
CMYK Target Profile | ON |
Paper Simulation | OFF |
Printer Profile Tab | Setting |
---|---|
Printer Profile | For coated paper |
Paper Type Link | OFF |
Optional Settings tab | Setting |
---|---|
Tone Curve - Image | No Setting |
Tone Curve - Text/Graphic | Same as Image |
Tone Curve - Keep 100% Density for Text/Graphics | OFF This function is not available on color machines. |
Pure Black | Text/Graphic |
Black Overprint | OFF |
Gray Replacement - RGB | Text/Graphic |
Gray Replacement - CMYK | Image/Graphics/Text |
Composite Overprint | Off |
Use Spot Color | ON |
AlternativeColor Table | No Setting |
Use Embedded RGB Profile | ON |
Use Embedded CMYK Profile | OFF |
RGB Simulation | OFF |
PDF/X output intent | OFF |
Use CIE Color | This function is not available on color machines. |
From the File menu, select Return to Factory Default.
The Initialization Check message is displayed.
Click Yes.
Resets the priority to the factory default.
supplementary explanationWhen you want to register the initialized settings of Color Default, go to Registering Settings.