Corner Staple
Overview
Copies are diagonally stapled in the left corner of the paper. This function is useful to staple documents with a small number of pages.
One of the following options is required to use this function.
- Finisher FS-541 with PostInserter PI-502 mounted
- FoldingUnit FD-503 with Finisher FS-541 mounted in the next stage
- PostInserter PI-502: The Lower tray can only be used as a paper tray. The Upper tray is not available.
- FoldingUnit FD-503: The Upper tray can only be used as a paper tray. The Lower tray is not available.
Setting Procedure (For PostInserter PI-502)
Copies are diagonally stapled in the left corner of the paper.
1
Load paper into the Lower tray of the PostInserter PI-502, and align the Side guides with the paper.
2
Press the Staple mode selection key [2] on the Post inserter control panel to turn on the Corner Staple mode LED lamp.
3
Press the Start/Stop key [3] to start processing.
Setting Procedure (For FoldingUnit FD-503)
Copies are diagonally stapled in the left corner of the paper.
1
Load paper into the Upper tray of the Post inserter of the FoldingUnit FD-503, and align the Side guides with the paper.
2
Press the Staple selection key [2] on the Post inserter control panel to turn on the Corner Staple mode LED lamp.
3
Press the Start/Stop key [3] to start processing.
- If the machine stops because double feeding was detected but did not actually occur, press Multi-feed detection key [1] to light up the Double Feed Detection OFF indicator LED.