The Post inserter is one of the optional devices that is used in this system.
The Post inserter, which is mounted on the finisher, allows you to perform post-processing (Corner Staple, 2 Position Staple, Fold & Staple, Fold, or Punch) for printed sheets.
Even if post-processing is required after printing, you do not need to perform reprinting.
On the Post inserter control panel of PostInserter PI-502 or FoldingUnit FD-503, the following post-processing can be performed depending on the combination with the optional device mounted in the finisher.
PostInserter PI-502 | Output (Finishing) | |
---|---|---|
Mode selection key | Only Tri-Fold can be selected on the Control panel of PostInserter PI-502. | |
Punch key | 2-Hole Punch can be selected on the Control panel of PostInserter PI-502. |
FoldingUnit FD-503 | Output (Finishing) | |
---|---|---|
Multi-feed detection key |
| |
Staple selection key | ||
Punch selection key | Punch | |
Fold selection key |