[Job was not sucessfully executed. An Error occurred while dialing. Please check Job History.]

Redial was attempted the number of times specified, however, transmission failed because the recipient was busy or due to other reasons.

Check the recipient's state and then resend the fax.

Using the Off-Hook key, you can check the sender status before sending. For details, refer to Sending after Checking the State on the Recipient Side (Manual Transmission).

[Unable to check sender.]

The machine failed to verify the recipient with Check Dest. & Send set to ON.

Check whether the fax number of the originating machine is registered in the destination machine.

[Not enough memory to continue scanning. Touch [Send] to transmit only the scanned portion of the document or [Delete] to cancel it.]

All the available space in the memory has been used up by document scanning.

To send the scanned document, use the Start key to start sending. To stop sending, use the Stop key.

[Transmission failed. Please check line connection.]

The modular cable may be disconnected.

Check the modular cable connection and, if unplugged, plug it in securely.

[Failed to connect to server.]

The network cable is not connected correctly.

Make sure that the network cable is correctly connected.

Under Administrator Settings, [Network] is not set correctly.

Under Administrator Settings, check that [Network] is set correctly.

[Cannot select address for TX. Exceeded the maximum number of addresses allowed for broadcasting]

The number of destinations specified exceeds the number possible for a broadcast transmission.

Reduce the number of broadcast destinations, or send the transmission in multiple batches.

[Document could not be saved in User Box. Insufficient Storage memory. Please check Job History.]

The storage is full.

Delete unnecessary data, then try saving the data again.

[The number of documents in the box has reached the maximum limit. No additional documents can be stored.]

The number of documents that can be saved in a User Box has reached the maximum number possible.

Delete unnecessary documents then retry registration.

[The number of programmed jobs has reachedthe maximum allowance. Please wait untila programmed job has been completed.]

The number of jobs that can be programmed has reached the maximum number possible.

Wait until a job has been completed, or delete a current job.