Workflow

[Send E-mail]

[Off], [On Error], [Always]

Set this to send an E-mail to a specified address after completing a print job.

[Print Mode]

[Normal], [Proof], [Proof(1st Sheet)], [Wait], [Spool].

Set a print method.

When [Normal] is selected, the print job is printed without being stored.

When [Proof] is selected, the print job is printed only partially, and you can view the print image. This function is helpful for sample printing.

When [Proof(1st Sheet)] is selected, the print job is printed only by the first page, and you can view the print image. This function is helpful for sample printing.

When [Wait] is selected, the print job is saved as an output-reserved job. To output such a print job, press Start on the control panel of this machine.

When [Spool] is selected, the print job is held on the machine, and then printed.
It can prevent the intermittent printing that may be observed when printing jobs with a lot of pictures, etc.

[Output Method]

[Print], [Print/Hold], [Hold], [Hold (Without RIP)], [Print/Store on HDD], [Store on HDD], [Secure Print], [Form]

Select the method to handle a print job that is to be sent from the computer to this machine. When [Print/Store on HDD], [Store on HDD], or [Secure Print] is selected as the method, you need to enter [Folder Name], [Password], [User Box Name], [Secure Print ID ], and [Password].

For details about [Hold] and [Hold (Without RIP)], refer to Hold and HDD Store for Print Job (PS Plug-in Driver).

For details about [Print/Store on HDD] and [Store on HDD], refer to Hold and HDD Store for Print Job.

For details about the [Secure Print], refer to Secure Print.

For details about [Form], refer to Printing Document Data over Master Data: Form (Overlay) Print.

[File Name]

-

Enter a name if you want to specify a name other than the file name of the original.

[File Transmission Setting]

[Off], [1] to [10]

The RIPed data is sent to the host (SMB server) registered on this machine. Once the RIPed data is saved, it can be used for digital inspection (comparison of data before and after RIP) and other purposes.

Destination ([1] to [10]) must be registered in [File Transmission Setting] of this machine in advance. For details, refer to Controller Administrator Setting.

[File Transmission Setting] is displayed by setting the Software Switch. For details about [Software Switch], refer to Controller Administrator Setting.