Home PrintPrinting over a form

Printing over a form

This machine allows you to recall the form registered in this machine and print a document over the form (Superimposition).

  1. Click [Form] of the [Forms] tab, then select the desired form name.

    • If the resolution of the form is different from that of the job, the form name is dimmed, which means the form is not available.
      The form resolution is displayed in [Resolution] under [Preview] after the form name has been selected.
      You can specify the resolution in the [Imaging] tab.

  2. In [Forms Print Mode], select [Repeated] or [Once].

    • [Repeated]: Superimposes a form on each page of a job to repeat printing. Only one or two pages can be set to a form.
      Example:
      When a form has two pages, form page 1 is assigned to the first page of the job, form page 2 to the second page of the job, and form page 1 to the third page again as shown below. This pattern is repeated.

    • [Once]: Superimposes a form on each page of a job once only to make prints.
      Example:
      When a form has two pages, form page 1 is assigned to the first page of the job, form page 2 is assigned to the second page of the job, and no form page is assigned to other pages as shown below.

  3. Click [OK] to start printing.