[AutoInspect.Report]
Overview
[AutoInspect.Report] is a function that allows you to check the result of [Auto Inspection].
This function provides 2 types of reports: report of printouts that satisfy the inspection level and report of printouts that do not satisfy the inspection level.
There are 2 methods to check [AutoInspect.Report].
If you access via a browser, you can check the report with the problem part framed.
NOTICE
All the following options are required to use this function.
- Intelligent Quality Care Unit IQ-501
- Auto Inspection Unit UK-301
- Relay Unit RU-702
- Video Interface Kit VI-514
- Video Interface Kit VI-515
NOTICE
The following setting is required to use this function.
- Set [Auto Inspection NIC Setting].
NOTICE
The following settings are required to create an automatic inspection report.
- Set [Create Auto Inspection Report] to [ON].
- Perform automatic inspection.
Reference
- For details about [Create Auto Inspection Report], refer to [Common Setting].
- For details about [Auto Inspection NIC Setting], refer to [Auto Inspection NIC Setting].
in the upper-right of a page, it turns into 
and is registered as a bookmark.