Cleaning This Machine
Cleaning the Slit Scan Glass
Perform this procedure when the Reverse Automatic Document Feeder DF-632 or Reverse Automatic Document Feeder DF-714 is installed on the machine.
1
Open the ADF.
2
Wipe stains off the Slit Scan Glass using a dry, clean cloth.
NOTICE
- Do not touch the Slit Scan Glass.
3
Close the ADF.
Cleaning the Slit Scan Glass (back)
Perform this procedure when the Reverse Automatic Document Feeder DF-714 is installed on this machine.
1
Open the ADF.
2
Open the Opening and Closing Guide.
Release the lock lever of the Opening and Closing Guide, and open the Opening and Closing Guide.
3
Wipe stains off the Slit Scan Glass (back) using a dry, clean cloth.
NOTICE
- Do not touch the Slit Scan Glass (back).
4
Close the Opening and Closing Guide you opened in step 2.
Press the Hand mark in the center of the Opening and Closing Guide, and check that the Opening and Closing Guide is locked securely.
5
Close the ADF.
Cleaning the Original Glass, Control Panel, and roller
Wipe the surface using a soft, dry cloth.
NOTICE
- Do not press the Control Panel hard, otherwise the Touch Panel may be damaged.
CAUTION
- The inside of this product has areas subject to high temperature, which may cause burns. When checking the inside of the unit for malfunctions such as a paper misfeed, do not touch the locations (around the fusing unit, etc.) which are indicated by a "Caution HOT" caution label. A burn could result.
Cleaning the outer covers and Original Pad
Wipe the surface using a soft cloth moistened with a mild household detergent.
NOTICE
- Never use solvents, such as benzene or thinner, to clean the Original Pad.
in the upper-right of a page, it turns into 
and is registered as a bookmark.