Sending a Fax after Specifying a Relay Station ([F-Code TX])

Relay distribution

The Relay Distribution function sends a fax to a relay machine, which distributes the received fax to a pre-registered group of destinations.

Overall communications costs can be reduced by grouping relay stations and destinations by area, compared to the case in which faxes are broadcast to all destinations. This function is useful when broadcasting faxes to distant locations.

Tips

  • The destination machine (the relay machine) needs to have the F-code function.

  • You need to check both the Relay User Box number specified on the relay machine and the password for relay distribution.

  • This function cannot be used together with the following functions:
    Password TX, Polling TX, Polling TX (Bulletin Board), Polling RX, Polling RX (Bulletin Board).

Related setting (for the administrator)

  • You can enable or disable F-Code TX (Default: [ON]). For details, refer to [F-Code TX] .

Reference

Operation flow

  1. Load the original.

  2. Tap [Scan/Fax].

  3. Specify the fax number of the relay station.

  4. Tap [Application] - [Fax Setting] - [F-Code TX], then tap [ON].

  5. Enter the [SUB Address] and [Sender ID], then tap [OK].

    supplementary explanation[SUB Address]: Enter the relay user box number.

    supplementary explanation[Sender ID]: Enter the relay TX password for the relay distribution.

    supplementary explanationTo display the Keypad, tap the input area for the numeral.

  6. Press the Start key.

    Fax transmission to the relay station begins. Faxes received by a relay station are delivered to destinations registered with the relay station.