Copy an original onto both sides of the paper.
[Original > Output]
Select a combination of the original to be loaded (1-sided original or 2-sided original) and the copy method (1-sided copy or 2-sided copy).
If you have selected other than [1Sided > 1Sided], also specify [Binding Position] and [Original Direction].
Select the binding positions of the original and copy.
[No. of Originals]
Select the original binding position when a 2-sided original is loaded.
Select the binding position when printing on both sides of paper.
Specify the orientation of the loaded original.
For details on how to operate [Original > Output], refer to Here.
Select the number of original pages to be copied on a single page.
If [4in1] or [8in1] is selected, you can select the combined page layout from [Horizontal] or [Vertical].
For details on how to operate [Combine], refer to Here.
Copy an original image repeatedly copied onto the same side of a single sheet.
Select [ON] to specify Image Repeat.
[Image Repeat Setting]
Select the copy method on the paper.
You can either to set the machine to automatically detect the scan range (original size), or specify the scan range manually.
If the original is of a standard size, selecting [Auto Detect] causes the machine to automatically detect the size. If the machine cannot detect the size of irregular sized originals or photos, manually specify the size.
If blank pages are included in the original loaded into the ADF, they are skipped when the original is scanned.
Select this check box when scanning an original containing blank pages. Any blank pages that are detected are not counted as original pages.
When you want to copy cards, you can arrange the front and back sides of the card on the same side of a single page and print them onto one sheet.
Select [ON] to specify Card Shot.
Specify the size of the card to copy by tapping [+]/[-] for the inch area, by tapping [+]/[-] or Keypad for the centimeter area. To display the Keypad, tap the input area for the numeral. From the [Registered Paper Size], you can recall a size previously stored and specify the size.
After you have entered the size, select a key in [Registered Paper Size], and tap [Register]. Then the size you have entered is registered in the memory. You can recall the registered size in the future.
[Registered Paper Size]
Displays the sizes registered in memory.
When you call a registered size from the memory, tap the key of the desired registration name, then tap [Recall].
Select the layout for arranging the front side and back side of the card on the paper from [Top/Bottom], [Left/Right (Top Half)], and [Left/Right].
Select a zoom ratio for copying.
[Change registered size name]
Change the name of the key you selected in [Registered Paper Size].
For details about the operation procedure of [Card Shot], refer to Here.