Sending a Fax
Checking the Fax Transmission Method
- To send a fax (Basic operation flow)
- To differentiate sender names for each destination ([Sender Settings])
Resending a Failed Fax
Sending at Low Cost
- To send a fax at the preset time (Timer TX)
- To broadcast via a relay station such as a branch office (Relay Distribution)
Sending According to the Conditions of the Recipient, This Machine, and Line Status
- To send after checking the status of the destination (Manual transmission)
- To send a fax after releasing ECM mode ([ECM])
- To send a fax after canceling Super G3 mode ([V34])
- To send data each time one page is scanned in order to prevent the memory from becoming full ([Quick Memory TX])
- To send a fax to areas where communication conditions are poor ([Overseas TX])
- To use different sending lines using additional lines ([Line specification])
Sending an Important Fax
- To check the destination fax number before sending a fax ([Check Dest. and Send])
- To send a confidential fax ([F-Code TX])
- To send to a device for which peers are restricted by the Closed Network RX function ([Password TX])