Sending after Specifying a Relay Station ([Line specification])
About line specification
When multiple lines are used, you can select a line for sending a fax.
Using additional lines enables you to send a fax using an idle line or assign lines to send a fax.
If the line specified to send a fax is not available because it is busy for communication, the job is placed in the standby state until the communication is completed.
When registering destinations with an address book, you can configure the lines used to send faxes in addition to registering fax numbers.
This function cannot be used together with the following functions.
Polling TX, Polling TX (Bulletin Board)
Preparation required to use this function (for the administrator)
Configure a specific function for additional line. If you set a specific function for each line, you can use each line for a different purpose.
For details on the setting procedure, refer to [Using an Additional Line] .
You cannot specify a line if [Multi Line Settings] is set to [RX Only].
Operation flow
Load the original.
Tap [Fax] on the home screen.
Specify the destination.
Tap [Line Settings].
Select a line used for transmission in [Line specification], and also tap [OK].
Use the Start key to start transmission.