Configuring Settings on the Control Panel of the MFP

Register MFPs to be operated in a serverless pull printing group using the Control Panel of the MFP. Up to 10 MFPs can be registered, including the MFP (this machine) to be configured.

Configure the following settings on all MFPs that make up a serverless pull printing group.

  1. Tap [Utility] - [Administrator Settings] - [System Connection] - [Serverless Pull Printing Settings] - [Serverless Pull Printing Group Setting].

  2. Tap [Registered Machine2] to [Registered Machine10].

  3. Select the method for specifying a registered MFP ([Input Host Name], [IPv4 Address Input], or [IPv6 Address Input]), specify MFPs to be registered in a serverless pull printing group, then click [OK].

Tips

  • If serverless pull printing group settings are configured using LK-114_SetupTool, this step is not required.

  • This method for specifying registered MFPs should be common to all MFPs that compose a serverless pull printing group.

  • To register the MFP with the host name, specify only the host name without the domain name (example: character string following the first dot (.) in "ServerlessPullPrint1.test.local"). A host name cannot be duplicated.

  • A serverless pull printing group cannot be structured over WAN.

  • To use the main unit for which [Network Settings] - [Network I/F Configuration] is set to [Wired + Wireless (Secondary Mode)], [Wired + Wireless (Primary Mode)], or [Wired + Wireless (Wi-Fi Direct)] as the storage machine for serverless pull printing , set a serverless pull printing group to the wired network interface of the storage machine.

Reference

  • When composing a serverless pull printing group involving different models, you need to permit the quick authentication. For details on how to permit the quick authentication, refer to [Permitting the quick authentication] .