Loading the Original into the ADF
Original available for ADF
Item | Specifications |
|---|---|
Original types | Plain paper (50 g/m2 to 128 g/m2 (13-5/16 lb to 34-1/16 lb)) |
Max. original size | A4 or 8-1/2 e 14 Fax mode: 216 mm to 1000 mm (8-1/2 inches to 39-3/8 inches) |
Original loading capacity | Max. 80 sheets (80 g/m2 (21-1/4 lb)) |
Do not load the following originals into the ADF. Doing so may cause an original paper jam, or damage the originals.
Wrinkled, folded, curled, or torn originals
Highly translucent or transparent originals, such as transparencies or diazo photosensitive paper
Coated originals such as carbon-backed paper
Original that weighs less than 50 g/m2 (13-5/16 lb), or more than 128 g/m2 (34-1/16 lb)
Originals that are bound, for example, with staples or paper clips
Originals that are bound in booklet form
Originals with pages bound together with glue
Originals with pages that have had cutouts removed or are cutouts
Label sheets
Offset printing masters
Photographic Paper
Glossy original such as gloss coated paper
How to load paper into the ADF
The ADF feeds original sheets one by one in order from the top, and automatically loads them. It also loads a 2-sided original automatically.
The ADF is helpful when loading a large number of original.
1
Widen the Lateral Guide.
2
Put the first page of an original at the top, and load the original into the Original Tray with the required side facing upward.
Load the original so that its top side is placed on the left. When loading in a different orientation, be sure to specify the loading direction of originals. For details on the loading direction of originals, refer to Specifying the original loading direction ([Original Direction]).
Pull out the Document Stopper (1) to prevent the scanned original from falling.
When the original width is 55 mm (2-3/16 inches) or less, align the Lateral Guide to the original width before loading the original.
NOTICE
- Do not load more than 80 sheets (80 g/m2 (21-1/4 lb)) at a time into the Original Tray of the ADF, and do not load the sheets up to the point where the top of the stack is higher than the
mark. Doing so may cause an original paper jam, original damage, or ADF failure. However, if the original contains more than 80 sheets (80 g/m2 (21-1/4 lb)), it can be scanned separately.
3
Slide the Lateral Guide to fit the loaded original.
in the upper-right of a page, it turns into 
and is registered as a bookmark.