Device Location
Install this machine in a location that can support its weight, including consumables and paper.
Configuration | Weight |
|---|---|
Main unit (including Imaging Unit, Toner Cartridge, and Waste Toner Bottle) | North America models: Approx. 35.3 kg (77-13/16 lb) Other models: Approx. 34.9 kg (76-15/16 lb) |
Install this machine in the location shown below.
Location of which the surface is rigid, flat, stable, and level (inclination of 1 degree or less all around the main unit)
To check whether the installation location is level, use a normal round pencil. If the pencil rolls, the location is not horizontal. Ensure this machine is horizontal, and make sure that there are no objects such as cables caught under this machine.
Location close to a dedicated power outlet that is grounded
Location close to your computer
Sufficiently spacious location that ensures ease of use and appropriate air ventilation
Location in which the ambient temperature is 10°C to 30°C (50°F to 86°F) and the humidity is 15% to 85%
Do not install this machine in the locations described below.
Location exposed to direct sunlight
Location in which excessive differences in temperature and humidity are detected due to close proximity to a heater or cooling equipment
Location exposed to direct flame or combustible materials
Location close to equipment such as a copy machine or air-conditioner that generates noise, or equipment such as a refrigerator that generates a strong magnetic or electromagnetic force
Location close to water, water pipes, or fluid (drink) containers, corrosive chemicals, or corrosive gases such as ammonia
Location in which fine metallic pieces such as clips or staples are scattered
Location subject to thumping vibrations
Location exposed to direct wind
Tips
- Do not connect to the same power outlet as that used for a high-current equipment.
- If this machine is installed in or moved to an environment subject to excessive changes in temperature, condensation will form in this machine, which may reduce printing quality. If condensation is detected, leave this machine for approximately 1 hour before using it in order to allow it to adapt to the environment.
- When using a humidifier or vaporizer in the room where this machine is installed, use purified or distilled water. If impurities in water are emitted into the air, they will collect in this machine and reduce printing quality.
- If the image processor's specific acoustic level, Lwad, exceeds 63 db, you may find operation sounds disturb you depending on your office environment. If this is the case, we recommend that you place a partition near the processor or place the processor in a separated location or in another room.
in the upper-right of a page, it turns into 
and is registered as a bookmark.