[IP Filtering (Permit Access)]
Overview
Sets the computer IP address range to allow connection with the system.
Up to 5 IP address ranges can be set from [Set 1] to [Set 5].
Tips
The following is an example of allowing only 1 IP address (example: when allowing 192.168.11.22).
- Enter "192.168.11.22 - 0.0.0.0"
- Enter "0.0.0.0 - 192.168.11.22"
- Enter "192.168.11.22 - 192.168.11.22"
Setting Procedure
1
Press [Enable].
To disable [IP Filtering (Permit Access)], press [Disable].
2
Select [Set 1].
The setting screen is displayed.
3
Enter the range of the IP address that allows a connection using the Keypad on the Control panel.
To move the cursor position, press
/
.Pressing [Delete] deletes the character directly to the left of the cursor when there is no character at the cursor position. If the cursor is on a character, that character is deleted.
4
Press [OK].
The entered range is specified, and the setting screen is closed.
5
Press [OK].
Also set another range as needed. The steps are all the same.
Was this information useful?
Thank you.
in the upper-right of a page, it turns into 
and is registered as a bookmark.