Scan to HDD
It can be used in a typical network environment, but requires the TWAIN driver to be installed on the receiving computer.
Step 1
Check and prepare the network.
You should be connected to a general TCP/IP network environment.
Step 2
Configure the required system settings.
[TCP/IP Settings]
[TCP Socket]
Step 3
Scan operation (select a destination and scan the original)
1. Select [HDD] on the [SCAN] screen.
2. Select a destination HDD box (the destination needs to be registered in advance).
3. [Scan Settings]
4. Load the original and scan.
Step 4
Operations on the receiving end (computer)
Install the TWAIN driver to the computer.
Import the data stored in the destination box.
in the upper-right of a page, it turns into 
and is registered as a bookmark.