[Paper Type & Weight]
Overview
Display the paper measurement result.
[Paper Type & Weight] allows you to check the following items.
Item | Description |
|---|---|
[Paper Type] | Displays the type of the measured paper. One of the following items is displayed.
|
[Weight(g/m2)] | Displays the weight of the measured paper. |
Reference
- For details about the paper size setting in addition to the paper type and weight, refer to [Paper Setting].
Setting Items
Screen access
Touch panel - [MACHINE] - [Paper Measuring] - [Paper Type & Weight]
Setting item | Description |
|---|---|
[Reg./Del.PaperSet.] | You can register one of the displayed profile candidates in the paper profile. After selecting the candidate, press [Reg./Del.PaperSet.]. For details about the [Reg./Del.PaperSet.], refer to [Reg./Del.PaperSet.]. |
[Change Unit] | Select the unit of the displayed weight. The unit is switched each time the key is pressed. |
[Detect Paper Info] | Moves to the [PRINT MODE] screen. |
[To Single Tray] | Only applies the setting to the selected paper tray. |
Setting Procedure (Using Intelligent Media Sensor IM-101)
1
In [Paper Tray], select the paper tray to load the paper.
2
For measuring purposes, prepare paper (1 sheet) to load in the paper tray.
3
Check if READY Lamp of Status Indicator Lamp on Intelligent Media Sensor IM-101 is lit in blue.
For information about the display of Status Indicator Lamp in Intelligent Media Sensor IM-101, refer to Checking the Status of Intelligent Media Sensor IM-101..
4
Insert the single sheet of paper prepared in step 2 into the back of Intelligent Media Sensor IM-101 with the print side facing up.
Match the center of the paper to the center of the opening of Intelligent Media Sensor IM-101, and insert the paper in the same direction as the actual feed direction.
The READY Lamp of the Status Indicator Lamp lights up when paper is being measured.
5
When READY Lamp of Status Indicator Lamp turns off, take out the paper.
6
Select the measurement result.
Select from the displayed candidates.
7
Press [To Single Tray].
The measurement result is reflected in the [Paper Tray] field on the [MACHINE] screen.
Setting Procedure (Using the Media Sensor Mounted on This System)
1
Select the paper tray loaded with the paper to be measured.
2
Press [Detect Paper Info] to display the [PRINT MODE] screen.
Multiple paper trays can be selected even on the [PRINT MODE] screen. The paper in the last selected paper tray is measured.
You can set the output destination of the paper used for measuring in [Output Setting].
3
Press Start on the Control panel.
Paper is measured. An error message is displayed in the following cases. Check the displayed contents, and take the appropriate action.
Conditions do not match the paper type or weight set for the paper tray.
Conditions do not match the paper profile set to the paper tray.
The measurement with the paper tray has failed.
NOTICE
- If [Measurement Failed] is frequently displayed, contact your service representative.
Tips
When confirming the measurement details on the error message screen, follow the steps below:
- Select the paper tray you want to confirm, and press [Details].
- Follow the message instructions to confirm the paper in the paper tray, and make any required changes.
4
Press [Exit PrintMode] to return to the setting screen.
5
Select the measurement result.
Select from the displayed candidates.
6
Press [To Single Tray].
The measurement result is reflected in the [Paper Tray] field on the [MACHINE] screen.
in the upper-right of a page, it turns into 
and is registered as a bookmark.