[Software Switch Setting]
Overview
Switching the corresponding switch numbers resolves phenomena or requirements described in the software memory switch setting list.
NOTICE
- Never change a switch number that is not described in the software memory switch setting list from [Off] to [On].
Reference
- The status (On or Off) of the software memory switch can be viewed on the report of [Machine Setting]. For details, refer to [Report Type].
Setting Procedure
1
Press the [<], [>], or keypad to select the switch number.
2
Press [On] or [Off].
[Software Switch Setting] List
Switching the corresponding switch numbers resolves phenomena or requirements described in the following list.
All the software memory switches are set to [Off] by default. Changing from [Off] to [On] may resolve a problem that occurred.
Switch No. | Problem/Requirement | Solution reached when turned On |
|---|---|---|
43 | If MIB (kmNetHttpdEnable) is changed from "disable" to "enable", the network setting, [HTTP Server Settings], on the Touch panel is set to [ON], but the setting on Web Connection is not changed. Select whether the setting on the Touch panel synchronizes the setting on Web Connection. | Setting value [Off]: Does not synchronize the Touch panel and Web Connection. [On]: Synchronizes the Touch panel and Web Connection. |
44 | Sub folders should be checked when performing SMB browsing of computers that have many shared folders. | Checks the subfolder box. However, this may take several minutes. |
62/63 | The status notification email indicating completion of a job should be sent. | Sends a notification mail to the administrator's address with the following settings. Setting value 62/63 = [Off]/[Off]: Does not send a notification email. 62/63 = [Off]/[On]: Always sends a notification email to the administrator's address. 62/63 = [On]/[Off]: Sends a notification email to the administrator's address only when an error occurs. |
83 | Select whether to save scan data sent to the OpenAPI application (Dispatcher Phoenix) in separate files for each page, or all in one file. | Setting value [Off]: Divides a file page-by-page. [On]: Collectively outputs all pages as a single file. The following formats can be used to save scan data in separate files for each page, or all in one file.
|
120 | A color space should be set by the Real Time Mode Twain driver. | Sets the following. [Off]: sRGB [On]: Adobe RGB |
121/122 | Special original settings such as Same Width should be allowed by the Real Time Mode Twain driver. | Sets the following. 121/122 = [Off]/[Off]: Normal 121/122 = [On]/[Off]: Same Width 121/122 = [Off]/[On]: Different Width 121/122 = [On]/[On]: Z-Folded |
123 | Thin paper should be set by the Real Time Mode Twain driver. | Sets the following. [Off]: Normal mode [On]: Thin Paper |
135 | A notification email should be sent to the email address specified in "Status Notification Setting" under [Network Setting] - [NIC Settings] - [Detail Settings] at the times specified in "Job started" and "Job finished". | Setting value [Off]: Does not send a notification email. [On]: Sends a notification email. Restrictions A notification email can only be sent to "E-mail address 1". |
164 | To send scanned data using email after login when [Authentication Method] of [User Authentication] is set to [External Server], the address of this email should be set to the administrator address of this system. | Changes the sender address of the email sent. Setting value [Off]: Disable (The address is specified to suit the environment (for example, the authentication user's address is specified).) [On]: Enable (The administrator address of this system is specified.) |
in the upper-right of a page, it turns into 
and is registered as a bookmark.