Adjustment
Q. How Many Sheets Can Be Read in [Scan Meas.]?
A. Max. 20 sheets.
For details, refer to [Scan Meas.].
Q. What Should I Do to Output a Background Sheet for Measurement in [Scan Meas.]?
A. Output the background sheet for measurement with a paper size of A3 or 11 e 17.
Q. What Should I Do at What Time to Perform Color Management?
A. Adjust the image quality before outputting a job.
Q. What Should I Do to Carry Out Calibration for Machine Color Management?
A. The density sensor of the optional Intelligent Quality Care Unit IQ-501 or Relay Unit RU-518m is required to carry out calibration for machine color management.
Perform [Color Density Control] using the density sensor of Intelligent Quality Care Unit IQ-501 or Relay Unit RU-518m. For details, refer to [Color Density Control].
Q. Can I Adjust the Color Tone on the Touch Panel?
A. Yes, you can.
Color tone can be adjusted using [Tone Curve Adjustment...] of [CNTL]. For details, refer to [Tone Curve Adjustment...].
Q. What Should I Do to Register the Adjustment Data Measured by the Colorimeter (i1Pro/i1Pro2, FD-5BT, MYIRO-1, or MYIRO-9 (FD-9)) in This System?
A. Store the data measured with Color Manager on a USB device (USB flash drive, etc.) or on a computer on the same network as this system, and then register it on this system.
Q. What Should I Pay Attention to When Measuring a Chart?
A. The colorimetry is affected, so pay attention to the colors of a thing under the chart.
For details about how to use the colorimeter, refer to its user's guide.
Tips
- The colorimetry is also affected by the color of a desk to put a chart on.
- For measurement, put a chart on white paper or a white board.
- For board, use the measurement board supplied with the colorimeter.
- For paper, pile 10 sheets or more of the same paper type as a chart.
Q. What Should I Do to Make This System Recognize the Adjustment Data Saved on a USB Flash Drive?
A. Create a "\C14000\ADJUST_DATA" folder just under the USB flash drive, and save adjustment data in the folder.
Q. What Is the Automatic Inspection Function?
A. Automatic inspection is a function that compares the registered reference image with the target image, and detects problematic output paper. A reference image for automatic inspection must be pre-registered.
Q. What Is the Automatic Inspection Area?
A. Set an area that is not subject to automatic inspection, or set an area that is subject to special inspection, such as variable printing, for example by changing part of an image intentionally. Efficient inspection is enabled by preventing unnecessary errors and automating checks such as serial number printing.
Reference
- For details about the automatic inspection area, refer to [InspectionAreaSet.].
Q. Can I Check the Result of Automatic Inspection?
A. Yes, you can.
For details, refer to [AutoInspect.Report].
in the upper-right of a page, it turns into 
and is registered as a bookmark.