Printing on Envelopes or Postcards
Printing on envelopes
Execute a print job on your computer then load envelopes into this machine to execute a print job on it.
The following explains how to print on standard-size envelopes loaded into the Bypass Tray.
1
Open document data using the application software. From the [File] menu, select [Print].
2
Check that the desired printer is selected in [Printer].
3
Select [Envelope] from [Paper Size].
Various sizes of envelopes are available. Select the correct paper size for the envelopes you have loaded.
If [Envelope] is selected, [Paper Type] is automatically set to [Envelope].
4
Execute printing.
The following screen is displayed.
5
When loading envelopes into the Bypass Tray, note the following points.
Do not use envelopes that have glue or release paper on the flap or the part covered by the flap on the body. Otherwise, the machine may be damaged or a failure may occur.
When loading envelopes, remove air from them, and securely press along the flap fold line. Otherwise, it will result in an envelope wrinkle or paper jam.
6
Position the flap part face up, and load envelopes as shown in the figure.
Insert envelopes into the tray until their edges are pressed against the back.
The flap side of envelopes cannot be printed on.
7
Slide the Lateral Guide to fit the size of the loaded paper.
8
Check that the paper size set to the Bypass Tray matches the size of the actually loaded paper, then tap [OK].
9
Tapping [Complete] starts printing.
If you cannot tap [Complete], check whether the paper setting of the printer driver matches that of the main unit. In addition, remove envelopes loaded in the Bypass Tray, then reload them.
Tips
- When loading envelopes into the Tray 1, refer to "Loading Paper" in [User's Guide [Introduction]].
Printing on postcards
Execute a print job on your computer then load postcards into this machine to execute a print job on it.
The following explains how to print on standard-size postcards loaded into the Bypass Tray.
1
Open document data using the application software. From the [File] menu, select [Print].
2
Check that the desired printer is selected in [Printer].
3
Select [Postcard] from [Paper Size].
If [Postcard] is selected, [Paper Type] is automatically set to [Postcard].
4
Execute printing.
The following screen is displayed.
5
When loading postcards into the Bypass Tray, note the following points.
When loading curled postcards, uncurl the postcards as shown in the figure in advance.
6
Load postcards into the Bypass Tray with the print side facing down.
Insert postcards into the tray until their edges are pressed against the back.
7
Slide the Lateral Guide to fit the size of the loaded paper.
8
Check that the paper size set to the Bypass Tray matches the size of the actually loaded paper, then tap [OK].
9
Tapping [Complete] starts printing.
If you cannot tap [Complete], check whether the paper setting of the printer driver matches that of the main unit. In addition, remove postcards loaded in the Bypass Tray, then reload them.
Tips
- When loading postcards into the Tray 1, refer to "Loading Paper" in [User's Guide [Introduction]].
in the upper-right of a page, it turns into 
and is registered as a bookmark.