HomeWeb Management ToolNotifying of the machine status via E-mail

Notifying of the machine status via E-mail

Overview

If a warning such as paper addition, toner replacement, or paper jam occurs on this machine, it can be sent to a registered E-mail address.

To send the machine status via E-mail, follow the below procedure to configure the settings.

  1. Configure settings for connecting to the network such as setting of the IP address of this machine

    • For details on configuring the setting, refer to Here.

  2. Configure the Scan to E-mail environment

    • For details on configuring the setting, refer to Here.

    • In the administrator mode, select [Network] - [E-mail Setting] - [E-mail TX (SMTP)], and set [E-mail Notification] to [ON].

  3. Configure the machine status notification settings

    • For details on configuring the setting, refer to Here.

Configuring the machine status notification settings

Register destination E-mail addresses. Up to 10 destination E-mail addresses can be registered. Also select warnings to send a notification when any of them occurs.

In the administrator mode, select [Maintenance] - [Status Notification Setting] - [E-mail Address] - [Edit], then configure the following settings.

Settings

Description

[Notification Address]

Enter the E-mail address of the destination with 320 characters, excluding spaces.

[Replenish Paper Tray]

Select this check box to send a notification when paper on tray runs out.

[JAM]

Select this check box to send a notification when paper jam occurs.

[PM Call]

Select this check box to send a notification when periodic inspection is required.

[Replace Staples]

Select this check box to send a notification when staples run out.

This function is only available in ineo+ 3851FS.

[Replenish Toner]

Select this check box to send a notification when toner runs out.

[Toner Near Empty]

Select this check box to send a notification when toner is running out.

[Finisher Tray Full]

Select this check box to send a notification when the finisher tray is full.

This function is only available in ineo+ 3851FS.

[Service Call]

Select this check box to send a notification when a service call occurs.

[Job finished successfully]

Select this check box to send a notification when a job is ended normally.

[Job Failed]

Select this check box to send a notification when a job is ended abnormally.

[Waste Toner Box Full]

Select this check box to send a notification when the waste toner box must be replaced.

[Waste Toner Box Near Full]

Select this check box to send a notification when it is almost time to replace a waste toner box.

[Imaging Unit Yield]

Select this check box to send a notification when the imaging unit must be replaced.